Holes Are Loose In Door Hinge

Another hint is to use a long screw in one of the holes in the top most hinge long enough to penetrate the stud.

Holes are loose in door hinge. Open the door wide and insert a wedge under the bottom outside corner to level it. Screws straight through the two holes toward the center of the door. This happened to my back door this year and i finally decided to take an hour and fix it. Screw through the middle hole and redrill the top screw hole at a slight angle so the screw hits solid wood.

If the hinge screws have been loose for only a short time you may need to tighten them with a screwdriver. The everbilt 3 1 2 in. But if the screws can t be tightened because the holes are stripped try this. Fix it the right way not the wrong way.

The small screws used to secure kitchen cabinet door hinges to the face frames of cabinets often work their way loose over time. But when hinge screws are left loose for a long time the constant movement of the hinge plate and screws enlarges the screw holes. Unless they re tightened immediately the screws will enlarge and strip the holes until it s impossible to tighten them. Door the everbilt 3 1 2 in.

A loose butt hinge will cause a door to hang crooked and stick. Door hinge 12 per pack has a removable pin to help with installation and removal of doors. If you have a loose hinge and you can t tighten it because the screws just spin in place the screw holes are probably stripped. You can see in the image below the loose screw was on my door lock striker.

Sometimes retightening the hinge screws is all it takes to fix the problem. However if the hinge has only three holes add a 3 in. A quick convenient cure can be found just inside one of the cabinets. After time the weight of the door will pull on the hinge and cause the door not to hang straight.

Eventually the holes become so large that the screws can t stay tight. The wrong way is a temporary fix not cool. If the door has a large hinge with four screw holes just drive 3 in. It kept backing out on its own.

If the loose holes are in a solid piece of wood like a door frame drill them out and fill them with wooden dowels to create a new surface for the screws to go into. I see this often on kitchen cabinet hinges and doors regular door hinges and areas that get worked or moved a lot.